proof
View the status of, or perform general commands on the proofing loader system.
The following command options are possible:
proof - Displays the status of all the proofing loader mechanisms and sensors.
proof init - Initializes the proofing loader mechanisms.
proof upgrade - Use this command after you have upgraded a trendsetter in the
field with the proofing option or when you are upgrading a trendsetter to
include the proofing option. (Obsolete after version 1.1). See the separate
command documentation for "proof startup" and "proof integrate"
proof startup - See the separate command documentation for "proof startup".
proof integrate - See the separate command documentation for "proof integrate".
proof usage - See the separate command documentation for "proof usage".
proof reseat - See the separate command documentation for "proof reseat".
proof mode - See the separate command documentation for "proof mode".
proof clean - See the separate command documentation for "proof clean".
proof c_verify - Use this command to test the carrier verification routine and
to calibrate the carrier hole position NVS parameter. See the separate command
documentation for "proof c_verify".
proof media seal - Perform the active media seal routine to seal the donor and
receiver to the drum. See the separate command documentation for "proof media seal".
proof cal - In the future this command will execute a calibration routine.
Trendsetter_400/800_Proofing
proof [init|reseat|startup|integrate|usage]
proof clean (drum|vr)
proof mode [off|c <proof type>|r|d <media type>]
proof c_verify (<pos>|mode <proof type>)
proof media seal
proof cal